047

Explanation
An unauthorized program issued a restricted Supervisor
Call (SVC) instruction:
Your program is authorized
if it has at least one of the following types of authorization:runs in supervisor state
Has PSW key 0-7
Is in an APF-authorized environment

System action
The system writes a logrec data set error record.

Operator response
If the system programmer asks for an SVC dump,
set the following SLIP trap: SLIP SET,COMP=047,ACTION=SVCD,END

System programmer response
Do the following: Ask the operator to set a SLIP trap to obtain an SVC
dump.
In the system trace, look for the SVC D or *SVCE D
entry for abend X'047'.
Look for an SVC entry preceding the entry found in
step 2. The SVC entry should be
for the same TCB and have the same ASID as the entry found in step 2. The PSW for this SVC entry contains
the address of the unauthorized program that issued a restricted SVC.
Use the PSW found in step 3 to
identify the unauthorized module that issued the restricted SVC. For an installation-provided module, continue diagnosis with the
module.
For an IBM® module whose
module prefix is IED or IKJ, the module is most likely a TCAM module.
Specify AUTHA=NO on the INTRO macro in the TCAM MCP program and run
the job again. If the problem recurs, search problem reporting data
bases for a fix for the problem. If no fix exists, contact the TCAM
group at the IBM Support Center.
Provide the SVC dump and the logrec data set error record.
For an IBM module that is
not part of TCAM, search problem reporting data bases for a fix for
the problem. If no fix exists, contact the component group associated
with this module at the IBM Support
Center. Provide the SVC dump and the logrec data set error record.

Source
Supervisor control