z/OS Security Server RACF Messages and Codes
Previous topic | Next topic | Contents | Contact z/OS | Library | PDF


IRRUT400 return codes

z/OS Security Server RACF Messages and Codes
SA23-2291-00

For the description and usage details of the IRRUT400 utility, see "RACF® database split/merge/extend utility program (IRRUT400)" in z/OS Security Server RACF Security Administrator's Guide.

For message explanations, see RACF database split/merge utility (IRRUT400) messages.

Table 1. Return codes for the RACF database split/merge utility (IRRUT400)
Hex (decimal) Explanation
0 (0) Successful completion without error.
4 (4) Duplicate IBM-defined names caused one or more warning conditions.
8 (8) One or more error conditions occurred because of one of the following reasons:
  • Duplicate non-IBM-defined names.
  • A defective tape volume set.
C (12) One or more severe error conditions resulted from an error on an output database.
10 (16) A terminating error condition occurred because of one of the following reasons:
  • A recovery environment could not be established.
  • The SYSPRINT file could not be opened.
  • An error was found in a parameter specification.
  • A range table was requested but could not be loaded.
  • An error was detected in the specified range table.
  • An error occurred on an input database.
  • The same data set was specified for input and output.
  • The output data set is an active RACF data set on this system.
20 (32) RACF is not enabled. Process ends.
Parent topic: RACF utility return codes

Go to the previous page Go to the next page

Notices | Terms of use | Support | Contact z/OS | zFavorites



Copyright IBM Corporation 1990, 2014