IRR52149I

Explanation
This message is issued when the RDEFINE or the
RALTER command specifies the STDATA segment, and the profile_name does
not appear to have the correct number of qualifiers to be useful.
The profile_name specified on the RDEFINE or the
RALTER command appears to have only one qualifier, or more than two,
therefore, is not used to process START commands. 
Note: All STARTED resource names are of the
format memname.jobname(or  memname.memname if
no jobnameis specified on the MVS™ START command). However, there are some cases
where the profile may have only one qualifier or three qualifiers
and still work.  For example:   If the STARTED profile name is &X, and the &X profile
in RACFVARS is defined as "RDEFINE RACFVARS &X ADDMEM(A.A)",
the profile would be used when starting procedure A with no job name.
A profile name of the form *.**.* (or several other unlikely generic
combinations) can be used to match names with two qualifiers.

System action
Except for the cases noted in the explanation,
the profile is not used to process MVS START
commands.

User response
Unless the profile_name matches
one of the exception cases noted in the explanation, you should delete
the profile using the RDELETE command and then use the RDEFINE command
to define a profile with the correct name.