z/OS JES2 Messages
Previous topic | Next topic | Contents | Contact z/OS | Library | PDF


$HASP190

z/OS JES2 Messages
SA32-0989-01

$HASP190

Explanation

Read syntax diagramSkip visual syntax diagram
>>-jobname-- SETUP  – --prtname-- –  F=--ffff-- – O=--name------>

>-- –  B=--+-Y-+-----------------------------------------------><
           '-N-'   

The indicated job requires that the setup of the 3800 printer device or AFP1 printer device with burster indicated by prtname be altered to forms = ffff, forms overlay = name, and burst mode or no burst mode.

Note: JES2 only issues $HASP190 for:
  1. channel-attached printers that are defined with PRINTER(nnnnn) SETUP=HALT,WS=(...F/).
  2. non-channel-attached (PSF FSS-driven printers that are SNA or TCP/IP attached) printers that are defined with PRINTER(nnnnn) SETUP=HALT,WS=(...F/) and with the PSF PRINTDEV statement that includes SETUP= in the PSF PROC. Be aware that this SETUP= setting is application-specific and you need to consult the appropriate user's guide before setting this value. For example, see the PSF book that documents the use of PRINTDEV SETUP=ALL | NONE | FORMS | BURST to understand which settings will prompt the $HASP190 message.

This allows JES2 to stop, issue this message, and wait until the operator verifies printer changes.

In the message text:
jobname
The name of the job.
prtname
The name of the printer.
ffff
The forms name.
name
The name of the overlay.
Note: A jobid may precede $HASP190. See JES2 message format.

System action

Output processing is halted on the specified device until an appropriate operator response is received. For burst mode, if the burster is not threaded, this message is repeated.

Operator response

Verify that the requested setup has been completed and enter a start ($S) command for the indicated 3800 printer device. If you want to override any or all of the setup specifications, do so with the set ($T) command followed by a start ($S) command. Current activity may be suspended by the restart ($E), interrupt ($I), and cancel ($C) commands. In this event, all intervening set commands are ignored, and the device setup is that before the setup message.

System programmer response

None.

Module

HASPPRPU, HASPFSSP

Routing Code: 7

Descriptor Code: 2

Go to the previous page Go to the next page




Copyright IBM Corporation 1990, 2014