$HASP186

jobname

Explanation

>>-jobname--OUTGRP=--grpid,joeid1,joeid2------------------------>

>--NOT SELECTED BY--device--DUE TO SECURITY POLICY-------------><

 JES2 processing does not select the output
group element identified by grpid.joeid1.joeid2 on
the specified device.
 In the message text:  jobname
The name of the job.
grpid
The group identifier. This is a 1– to 8–character
alphameric name either specified by the user's JCL or generated by
JES2.
joeid1
This number is assigned by JES2 and is used to uniquely identify
job output elements within the output group.
joeid2
This number is assigned by JES2 and determines the number of job
output elements within the output group identified by grpid and joeid1.
device
The device name for an output device or the job number/procname.identifier of
the task attempting output selection through the PSO interface. JES2 device name for physical device (for example, PRT1)
job number/procname.identifier of the requesting
task for the PSO interface 
job number/procname.identifier.threadid of
the requesting task for the SAPI interface. The SAPI application provides
the threadid.

 Note: A jobid may precede $HASP186. See JES2 message format.

System action
 JES2 discontinues HARDCPY processing on the device
for the specified job output group element ($JOE), and continues to
scan for the next BEST JOE. JES2 will remember that the device cannot
select the specified JOE and will skip that JOE for the specified
device until the device is restarted, JES2 is restarted or the output
group element is modified through operator commands.
 If an
access violation occurs, and you have DEBUG SECURITY=YES, JES2 issues
this message, and RACF® issues message ICH408I and
writes an SMF TYPE80 (X'50') record which includes LOGSTR
information.  The LOGSTR identifies the problem as either:  JES2 DEVICE WORK SELECTION SCREENING
EXTERNAL WRITER WORK SELECTION SCREENING
SAPI - DATA SET ACCESS

Operator response
 Notify the system programmer.

System programmer response
 Select one of the following actions
based on your environment set up:  If security is intended to act as a work selection criterion and
another device can select the output group element, no action is required.
If the output group element was routed to the wrong device, modify
the output to go to a device on which it can be processed using operator
commands.
If the output group element should have been selected by the device,
update any security definitions or profiles for the device and restart
the device.
If you need to determine why JES2 issued this message or you are
running in RACF warn mode and need to know if this message
would also occur in fail mode, set DEBUG SECURITY=YES.

System programmer response
 None.

Module
 HASPJOS, HASPPSO
 Routing Code: –
 Descriptor
Code: –