Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
$HASP180 z/OS JES2 Messages SA32-0989-01 |
|
$HASP180 ExplanationThe specified job has requested that image id be loaded into either the printer device forms control buffer (FCB), or the universal character set (UCS). A search of all images has shown that an I/O error occurred during an attempt to read from SYS1.IMAGELIB or a load error occurred during an attempt to load the image into the printer. Channel 1 must be defined in the image, otherwise the INVALID message results. This error can occur if the FCB or UCS was added to SYS1.IMAGELIB after JES2 was up and the new FCB or UCS caused SYS1.IMAGELIB to expand into a new extent. In this case, JES2 must be restarted to pick up the new FCB or UCS. In the message
text:
Note: A jobid may precede $HASP180. See JES2 message format.
System actionProcessing of the indicated job is halted. Operator responseEnter the $DU command to see the current status. Then use the $T command to correct the indicated error. If FCB is indicated in the message and you have a non-impact printer, ensure that the forms settings on the printer correspond to the FCB specifications. System programmer responseNone. ModuleHASPPRPU Routing Code: 7 Descriptor Code: 2,4 |
Copyright IBM Corporation 1990, 2014
|