$HASP119

jobname

Explanation

>>-jobname--DELETED--+----------+------------------------------><
                     '- –  text-'   

 The input service processor has deleted the
indicated job. The cause for the deletion may be that the operator
entered a command to cause the deletion or an error may have been
encountered while inputting the job (for example, if JESYSMSG could
not be created). When input errors are encountered, a previously displayed
message details the nature of the error. In addition to previous messages,
text, if present, will describe the reason for the deletion.
 In
the message text:  jobname
The name of the affected job.

 text will be one of the
following:  ILLEGAL JOB CARD, RC=1
The JOB statement was found to be incorrect by the input service
processor.
ILLEGAL CONTROL CARD (EXIT 4/54), RC=2
The JECL/JCL installation exit routine (Exit 4/54) has notified
the input service processor that it has detected an illegal control
statement.
MISSING CONTINUATION, RC=3
On an input JCL line, the input service processor found either
a non-blank character in column 72 or a comma at the end of the last
operand and the following input JCL line began with a /*.
/*DEL or /*PURGE JECL, RC=4
The input service processor detected a /*DEL or /*PURGE JECL statement
in a JCL stream from an internal reader.  Note: JES2 generates a /*DEL
if MVS™ closes an open internal reader data set on
behalf of an ABENDing TCB.

OPERATOR COMMAND, RC=5
An operator command was issued against the job in input processing
that requested the job be deleted.
INTERNAL PROCESSING ERROR, RC=6
An internal logic error was detected by the input service processor.
I/O ERROR, RC=7
When attempting to read the JCL stream for a job, the input service
processor detected an I/O error.
ILLEGAL JECL CARD, RC=8
The input service processor detected an error on a JECL card.
ILLEGAL EXECUTION NODE, RC=9
The input service processor detected an incorrect execution node
for a JOB.
EXCESSIVE SYSIN STATEMENTS, RC=10
The job being processed by the input service processor has more
SYSIN data sets than can be represented within the total number of
buffers available on this member.
DEVICE CANCELLED OR STOPPED, RC=11
The input service processor has detected that it's associated
device has been canceled or stopped. This may be the result of an
operator command or a request by the device to terminate processing.
ILLEGAL JOB CARD ACCT FIELD, RC=12
The input service processor detected that the accounting information
on the job card is missing or incorrect.
SECURITY PROCESSING ERROR, RC=13
An internal logic error was detected by the input service processor
while attempting to perform security validation.
NJE PROTOCOL ERROR, RC=14
The input service processor detected a violation of the NJE protocol.
NON-VALID // XMIT CARD, RC=15
The input service processor detected an error on a // XMIT JCL
card.
NON-VALID // DD DATA CARD, RC=16
The input service processor detected an error in a // DD DATA
JCL statement.

 Note: A jobid may precede $HASP119. See JES2 message format.

System action
 The job is routed to the print phase for appropriate
action and then purged.

Operator response
 Report this message to the system programmer.

Programmer response
 Correct the problem as appropriate and
resubmit the job.

Module
 HASCINJR, HASCSRIP, HASPRDR
 Routing
Code: 7
 Descriptor Code: 4