Configuring NCPROUTE

Procedure

Perform the following steps to configure NCPROUTE:

  1. Specify configuration statements in hlq.PROFILE.TCPIP.
  2. If using SNALINK, configure VTAM® and SNALINK applications.
  3. If using IP over CDLC, configure IP over CDLC DEVICE and LINK statements.
  4. Update the NCPROUTE cataloged procedure.
  5. Update hlq.ETC.SERVICES.
  6. Configure the host-dependent NCP clients.
  7. Configure the NCPROUTE profile data set for SNMP support and specification of an NCPROUTE gateways data set (optional).
  8. Configure the NCPROUTE gateways data set for each NCP client (optional).
  9. If OMPROUTE is not used, define a directly connected host route to each NCP client.

Results

Figure 1 shows the network addresses used in the configuration examples:
Figure 1. NCPROUTE example configuration
NCPROUTE example configuration
Parent topic: NCPROUTE