EZD0048I

Explanation
 The WORKLOADQ parameter was specified on the INTERFACE
statement for this  device in the TCP/IP profile. The OSA-Express
adapter microcode level for this  device does not support QDIO inbound
workload queueing.  
 In the message text:  interface_name
The name of the interface. 

System action
 TCP/IP activates the device without QDIO inbound
workload queueing enabled.

Operator response
 Contact the system programmer.

System programmer response
 Either install an OSA-Express Licensed
Internal Code (LIC) level that supports QDIO inbound workload queueing
or remove the WORKLOADQ parameter from the  INTERFACE statement. QDIO
inbound workload queueing is limited to OSA-Express3  ethernet features
in QDIO mode (CHPID type OSD) that are running on an IBM® System z10™.
 Use the VTAM® DISPLAY TRL command
to determine what OSA-Express LIC level is currently installed. See
the information about the DISPLAY TRL command in z/OS Communications Server: SNA Operation for more information.  See the 2097DEVICE
 Preventive Service Planning (PSP) bucket and the 2098DEVICE Preventive
Service  Planning (PSP) bucket for the OSA-Express LIC levels required
for QDIO inbound  workload queueing support.   
 See the information
about the QDIO inbound workload queueing in z/OS Communications Server: IP Configuration
Guide for information about the networking affects
of configuring with and without the WORKLOADQ parameter.

User response
 Not applicable.

Problem determination
 Not applicable.

Source
 z/OS® Communications
Server TCP/IP

Module
 EZBIFIND

Routing code
 2,8

Descriptor code
 12

Automation
 None.

Example
  EZD0048I INTERFACE OSAQDIO4 DOES NOT SUPPORT QDIO INBOUND WORKLOAD QUEUEING