You may need to initialize PCI Cryptographic Coprocessors after
system initialization.
Follow this procedure.
- Select option 1, COPROCESSOR MGMT, on the Primary Menu panel.
- The Coprocessor Management panel, as shown in Figure 75,
appears.
Figure 75. Selecting a coprocessor on the Coprocessor Management Panel
CSFCMP00 ---------------- ICSF Coprocessor Management -------------
COMMAND ===>
Select the coprocessors to be processed and press ENTER.
Action characters are: A, D, E, R, and S. See the help panel for details.
COPROCESSOR MODULE ID/SERIAL NUMBER STATUS
----------- ------------------------------- -------
_ A06 ACTIVE
_ A07 ACTIVE
_ C0 E589C396944007A6 5D40369997A386F4 ACTIVE
_ C1 0AA379BFD2387960 0367DC04533125FF ACTIVE
_ P00 41-00YE1 ACTIVE
_ P01 41-00K11 ACTIVE
_ P02 41-0A355 ACTIVE
E P03 41-0BA3F ONLINE
_ P04 41-0RT2T DEACTIVATED
_ P05 41-00342 DISABLED
- Select the Coprocessor to be processed by entering 'E'
next to the Coprocessor.
- The Master Key Entry panel appears. See Figure 76.
Figure 76. The Master Key Entry Panel to Reset Registers
CSFDKE10------------- ICSF - Master Key Entry -----------------
COMMAND ===>
CCF DES/PCICC SYM-MK new master key register : EMPTY
CCF Signature/PCICC ASYM-MK master key register : EMPTY
CCF Key management master key register : EMPTY
Specify information below
Key Type ===> ___ (DES, SMK, KMMK, ALL-PKA)
Part ===> ______ (RESET, FIRST, MIDDLE, FINAL)
Checksum ===> 00
Key Value ===> 0000000000000000
===> 0000000000000000
===> 0000000000000000 (SMK, KMMK and ALL-PKA only)
Press ENTER to process.
Press END to exit to the previous menu.
Ensure that the CCF Signature/PCICC ASYM-MK master
key register field indicates EMPTY. If it does not, you will need
to RESET to clear the contents of the registers to set a new key value.
- You must now load the SYM-MK and ASYM-MK keys into your system.
If
you are going to reload your current master keys, you need to know
the current master key value and checksum. If you want the PCICC
to become ACTIVE after CCF initialization, you MUST enter the same
master key values.
Follow the instructions on Steps for entering the first master key part.
- When all key parts have been loaded, SET the master key. From
the Primary Menu panel choose option 2 - Master Key. From the Master
Key Management panel, choose option 2 - SET MK.
|