To allow BRMS to aid you through the recovery process, you must now recover the BRMS product and associated libraries. The commands you use to recover these saved libraries will be different depending on whether the save type for the library was full (*FULL), incremental (*INCR), or cumulative (*CUML).
**************************************************************************************************** STEP 004 : Recover the BRMS Product and Associated Libraries Start date/time __________________ Stop date/time __________________ Duration _________________ The BRMS product and associated libraries must be recovered before you can use the product to perform other recovery operations. Change the QSYSOPR message queue to prevent messages not related to the recovery from interrupting the recovery process. To do so, type the following command then press "Enter". CHGMSGQ MSGQ(QSYSOPR) DLVRY(*NOTIFY) SEV(99) Review and select from the devicesconfigured on the system, the tape or media library devices you intend to use for the recoveries to follow. For tape devices, run the following command. WRKCFGSTS CFGTYPE(*DEV) CFGD(*TAP) For media library devices, run the following command. WRKCFGSTS CFGTYPE(*DEV) CFGD(*TAPMLB) Type your command choice then press "Enter".
Recover the libraries listed below specifying the saved-item, the device name of the stand-alone drive or media library you are using, and the volume identifiers and sequence numbers listed. For type *FULL, run the following command. RSTLIB SAVLIB(saved-item) DEV(device-name) VOL(volume-identifier) SEQNBR(sequence-number) For type *CUML or *INCR, run the following command. RSTOBJ OBJ(*ALL) SAVLIB(saved-item) DEV(device-name) VOL(volume-identifier) SEQNBR(sequence-number) MBROPT(*ALL) Type your command choice then press "Enter".
--- Attention ------------------------------------------------------- If you did not save access paths when you saved the QUSRBRM library, these access paths will be rebuilt when the library is restored. Verify rebuild of the access paths for files in library QUSRBRM is complete before proceeding to the next recovery step. To do so, type the following command then press "Enter". EDTRBDAP --------------------------------------------------------------------- After recovering the saved items, verify the BRMS product is installed correctly and the BRMS commands are available. To do so, type the following command then press "Enter". CHKPRDOPT PRDID(5770BR1) --- Objects --- Saved Save ----- ASP ------ Save Save Not Sequence Control Volume Item Type Name Number Date Time Saved Saved Number Group Identi ---------- ------- ---------- ----- -------- -------- ------- ------- --------- ---------- ------ __ QUSRBRM *FULL *SYSBAS 00001 7/25/05 11:35:30 181 0 56 *BKUGRP VOL002 __ QBRM *FULL *SYSBAS 00001 7/25/05 14:43:38 1,007 0 15 *SYSGRP VOL003 __ QMSE *FULL *SYSBAS 00001 7/25/05 14:43:38 7 0 52 *SYSGRP VOL003 __ Q1ABRMSF01 *FULL *SYSBAS 00001 7/25/05 14:43:38 1 0 106 *SYSGRP VOL003 __ Q1ABRMSF02 *FULL *SYSBAS 00002 7/25/05 14:43:38 1 0 107 *SYSGRP VOL003 ****************************************************************************************************