Clearing the ERDS

When ERDS is almost full, the recording routines sense it and issue a message.

Run EREP with the parameters required to clear the ERDS (only MVS and VSE use IFCOFFLD).

Important: This EREP run may request a system summary; but it should always include ACC=Y and ZERO=Y, to write the contents of the ERDS to another file and to clear the ERDS so the recording routines can write more records to it.

For information on your operating system’s procedures, see the topics shown in the following table:

OP. SYSTEM	REFER TO
MVS	Clearing the ERDS When Near Full on MVS
VM	Clearing the ERDS when Near Full on VM
VSE	Clearing the ERDS when Near Full on VSE