Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
BLWH0002E z/OS MVS System Messages, Vol 3 (ASB-BPX) SA38-0670-00 |
|
BLWH0002E A problem was found for a device specified in the AutoIPL
policy. ExplanationCHECK(check_owner,check_name)
found a problem during device validation for a device specified in
the AutoIPL policy. This message is followed by message BLWH901I,
which lists information about invalid devices specified in the AutoIPL
policy. The device must meet the following conditions to pass device
validation:
System actionThe system continues processing. Operator responseReport this to your system programmer. System programmer responseExamine logs to determine which AutoIPL policy devices do not pass the device validation. Resolve the problem either by specifying a new device in the DIAGxx parmlib member or by updating the existing device characteristics. Cause MVS™ to read the DIAGxx parmlib member by issuing a SET DIAG =xx operator command. Problem determinationN/A ModuleBLWHCCHK SourceLoadwait/Restart Reference DocumentationAutomationN/A Routing CodeSee note 35. Descriptor CodeSee note 1. |
Copyright IBM Corporation 1990, 2014
|