Changes made in SMP/E Version 1 Release 5

This section lists the changes that were made in SMP/E Version 1 Release 5.

SA22-7771-14

Changed information:

The syntax diagram showing the SYSOUT DDDEF UCLIN operands was corrected. For details, see SYSOUT data set.

Changed information:

The JCLIN command was updated for the following two changes:
- A blank space is no longer required between the closing parenthesis and TYPE comment in the JCLIN INCLUDE statement.
- X'C0' is a valid character in a module name that is specified on the INCLUDE statement.
- The notes in The UCLIN command were updated to explain that the SOURCEID value cannot span lines and must be explicitly specified.

New information:

You can use the REPORT MISSINGFIX command (The REPORT MISSINGFIX command) to determine whether any FIXCAT APARs exist that are applicable but are not installed yet, and whether any SYSMODs are available to satisfy the missing FIXCAT APARs. The Missing FIXCAT SYSMOD report was also been added; see Missing FIXCAT SYSMOD report.

Changed information:

You can now use the ZONEEDIT command to add certain subentries to selected SMP/E entries in the same zone. The ZONEEDIT command has been updated to describe this change.
The description of the SOURCEID operand, the EXSRCID operand, or both have been updated for the following commands:
The notes in The UCLIN command have been updated to explain that the SOURCEID value cannot span lines and must be explicitly specified.
The Data sets used sections in ACCEPT command, The APPLY command, and The RECEIVE command have been updated to include the optional data set SMPHRPT.
The following chapters are updated for the FIXCAT operand: