The Timeout Processing sample shows how to use the TimeoutControl and TimeoutNotification nodes to add timeouts to message flows. The Timeout nodes are controlled by timeout requests in incoming messages, based on a start time, an interval, and a count. This sample contains flows that demonstrate the following:
NOTE: In WebSphere Message Broker Version 8.0, IBM Integration Bus 9.0 and later, message model schema files contained in libraries are the preferred way to model messages for most data formats, including the new DFDL domain. Message sets continue to be supported, and are required if you use the MRM or IDOC domains. You can continue to import and deploy message sets for use in message flows. However, if you need to create one or more message sets, message definitions, or message categories when using this sample, you must first enable message set development in the IBM Integration Toolkit. For more information, see Enabling message set development in the IBM Integration Bus documentation.
Click the following links to find out more about the sample and how to get the prebuilt sample to run by using the wizards.
Import and deploy: 5 minutes
You can set up the sample in one of the following ways:
You can import or import and deploy a sample only when you use the information center that is integrated with the IBM Integration Toolkit.
When you have finished with the sample, you can remove it in one of the following ways: