MQHeader node sample

This sample consists of one message flow, with corresponding MQHeader nodes, which demonstrate the different ways in which you can use an MQHeader node. The ADD_DELETE_MQMD_MQHeaderNode message flow demonstrates the creation and removal of an MQMD header:

NOTE: In WebSphere Message Broker V8.0 or IBM Integration Bus Version 9.0 and later, message model schema files contained in libraries are the preferred way to model messages for most data formats, including the new DFDL domain. Message sets continue to be supported, and are required if you use the MRM or IDOC domains. You can continue to import and deploy message sets for use in message flows. However, if you need to create one or more message sets, message definitions, or message categories when using this sample, you must first enable message set development in the IBM Integration Toolkit. For more information, see Enabling message set development in the IBM Integration Bus documentation.

Click the following links to find out more about the sample and how to get the prebuilt sample running by using the wizard.

Import and deploy: 5 minutes

Read about the sample

You can set up the sample in one of the following ways:

• Import and deploy the sample

  This option imports the sample files into your workspace and deploys the sample to the broker. This option also sets up additional resources for the sample, for example, WebSphere MQ queues.

• Import the sample

  This option imports the sample files into your workspace. Additional manual steps might be required to configure the sample for testing.

You can import or import and deploy a sample only when you use the information center that is integrated with the IBM Integration Toolkit.

Running the sample

When you have finished with the sample, you can remove it in one of the following ways:

• Remove the sample from the broker, but leave its resources in the workspace
• Remove the sample from the broker and the workspace