JD Edwards Connectivity sample

The JD Edwards Connectivity sample consists of a single message flow that demonstrates how to use the JDEdwardsRequest node.

In the JDEdwardsRequest node scenario, a message flow is used to retrieve a record from JD Edwards.

NOTE: In WebSphere Message Broker Version 8.0 and IBM Integration Bus, message model schema files contained in libraries are the preferred way to model messages for most data formats, including the new DFDL domain. Message sets continue to be supported, and are required if you use the MRM or IDOC domains. You can continue to import and deploy message sets for use in message flows. However, if you need to create one or more message sets, message definitions, or message categories when using this sample, you must first enable message set development in the IBM Integration Toolkit. For more information, see Enabling message set development in the IBM Integration Bus documentation.

To find out more about the sample and how to get the prebuilt sample to run by using the wizards, click the following links:

Import and deploy: 5-10 minutes

Read about the sample

Setup instructions

You can set up the sample in one of the following ways:

Import and create a JDERequestSample execution group
This option imports the sample files into your workspace and deploys the sample to the integration node. This option also sets up additional resources for the sample, for example, execution groups. Additional manual steps might be required to configure the sample for testing.
Import the sample
This option imports the sample files into your workspace. Additional manual steps might be required to configure the sample for testing.

You can import or import and deploy a sample only when you use the information center that is integrated with the IBM Integration Toolkit.

Run the sample

When you have finished with the sample, you can remove it in one of the following ways: