Use the startcomponent command to start a broker when its controller (control process) is already running, or the start (/S) command to bring a broker into a state in which you can run the appropriate change command.
Command | Description |
---|---|
/S Broker started task name | Starts the broker. |
/F Broker started task name,SC | Starts the broker from a 'stop component' state. |
When the controller address space is started, the broker starts automatically. You can change this behavior by using an optional start parameter in the started task. If you set the parameter to MAN, the broker does not start automatically; the default is AUTO.
Issuing commands against the controller means issuing start, stop, or modify commands from the console to the controller address space. Two scenarios apply when you use this command:
/F MQ00BRK,sc