Reassemble the stand-alone dump program
Description
The stand-alone dump program produces a dump of storage that is occupied by a system that failed or a stand-alone dump program that failed. You must reassemble the stand-alone dump program each release. When the stand-alone dump program is properly created on a DASD residence volume, it resides in the SYS1.PAGEDUMP.Vvolser data set.
Table 1 provides more details about the migration action. Use this information to plan your changes to the system.
| Element or feature: | BCP. |
|---|---|
| When change was introduced: | General migration action not tied to a specific release. |
| Applies to migration from: | z/OS V2R1 and z/OS V1R13. |
| Timing: | Before the first IPL of z/OS V2R2. |
| Is the migration action required? | Yes. |
| Target system hardware requirements: | None. |
| Target system software requirements: | None. |
| Other system (coexistence or fallback) requirements: | None. |
| Restrictions: | None. |
| System impacts: | None. |
| Related IBM® Health Checker for z/OS® check: | None. |
Steps to take
Follow
these steps:
- Reassemble the stand-alone dump program. If you install z/OS with a ServerPac, an installation dialog job is provided to perform this action. If you install z/OS with a CBPDO, instructions to perform this action are provided in z/OS MVS Diagnosis: Tools and Service Aids.
Reference information
For more information,
see the following references:
- ServerPac: Installing Your Order
- z/OS MVS Diagnosis: Tools and Service Aids