| ASIRFMSG |
The SSCPs issue messages IST890I
and IST896I when an autologon session initiation request fails |
| CNMTAB |
Specifies the name of the communication
network management (CNM) routing table used to route unsolicited request
units |
| CNNRTMSG |
Specifies whether VTAM® is to suppress messages when an optimal
CNN route exists and is not chosen during session activation |
| DSIRFMSG |
The SSCPs issue messages IST663I,
IST664I, IST889I, and their message groups when searches that do not
result in a session fail to locate the target resource |
| DSPLYDEF |
Limits the number of messages displayed
when certain DISPLAY commands are issued without the MAX operand |
| DSPLYMAX |
Limits the value that can be specified
for the DSPLYDEF start option and for the MAX operand on certain DISPLAY
commands |
| DSPLYWLD |
Whether wildcards are permitted in
certain DISPLAY commands |
| ESIRFMSG |
The SSCPs issue messages IST891I,
IST892I, and IST893I when a session initiation request fails and extended
sense data exists |
| FLDTAB |
Specifies whether VTAM uses a message-flooding prevention table
to suppress duplicate messages |
| FSIRFMSG |
The SSCPs issue messages IST894I,
IST895I, IST1704I, and IST1705I when a session initiation request
fails because VTAM is unable
to locate the destination LU by using an adjacent SSCP table |
| HPRITMSG |
Specifies whether VTAM should
issue the enhanced version or base version of HPR activation and deactivation
messages |
| HPRPSMSG |
Specifies whether VTAM should
limit the number of HPR path switch messages that are issued |
| IOINT |
The interval after which the VTAM operator is notified of outstanding I/O
requests |
| IOMSGLIM |
The maximum number of IST530I and
IST532I message pairs that are written for individual subareas by
the IOPD facility |
| LSIRFMSG |
The network nodes issue messages
IST663I, IST664I, IST889I, and subordinate messages when APPN locate
searches fail to locate the target resource. |
| MSGLEVEL |
Whether VTAM is to issue the level of messages containing
network-qualified names |
| MSGMOD |
Specifies whether VTAM is to insert in messages the name of the
module that issued the message |
| PLUALMSG |
Specifies whether to suppress duplicate
session setup failure messages associated with LOGAPPL failures to
the same PLU |
| PPOLOG |
Specifies whether to send operator
commands and their resulting messages to the primary program operator
for logging |
| RSIRFMSG |
The SSCPs issue messages IST1460I, IST1461I,
IST2102I, IST2103I, and IST2104I when a session initiation request
fails and RSCV data exists |
| SIRFMSG |
The SSCPs issue IST663I, IST664I,
IST889I, and subordinate messages when a session initiation request
fails |
| SLOWVAL |
The interval after which the VTAM operator is notified that
a resource is in SLOWDOWN mode or is taken out of SLOWDOWN mode by VTAM |
| SLUALMSG |
Specifies whether to suppress messages
for session setup failures that occur because the SLU is not enabled |
| SUPP |
The message suppression level for
the operator console |
| VARYWLD |
Specifies whether wildcards are permitted
in certain VARY commands |