Operator modify commands

F ALSLIST command
F APINGDTP command
Change the number of APINGD transaction programs permitted to run concurrently for responding to APING requests from other nodes:
F APINGTP command
Change the number of APING transaction programs permitted to run concurrently for sending APING command requests to other nodes:
F BFRUSE command
Dynamically change the total amount of common service area (CSA) storage that VTAM is allowed to use for the IO buffer pool:
F CDRM command
Change the owner (external CDRM) of a particular cross-domain resource (CDRSC) or set of CDRSCs:
F CHKPT command
Save a copy of the directory database or the topology database (or both) to a checkpoint data set:
F CNOS command
F COMPRESS command
F CSALIMIT command
Dynamically change the amount of common service area (CSA) storage that VTAM is allowed to use:
F CSDUMP command
F CSM command
F DEFAULTS command
F DEFINE command
F DIRECTRY command
F DR command
F DUMP command
F ENCR command
F EXIT command
F GR command
F IMR command
F INOPCODE command
F INOPDUMP command
F IOPD command
F IOPURGE command
F LINEDEF command
F LL2 command
F LOAD command
F MSGMOD command
F NCP command
Send a request to NCP to execute the specified command for the specified resource:
F NEGPOLL command
Request that an NCP change the negative polling limit (the maximum number of consecutive negative polling responses accepted before polling another terminal on the line) for a nonswitched, multipoint line to one or more attached start/stop or BSC terminals:
F NOTNSTAT command
Terminate global or TRLE tuning statistics:
F NOTRACE command
F POLL command
Request that an NCP change the polling delay (the time delay between polling sequences) for a nonswitched, polled line to one or more attached BSC IBM® 3270 terminals:
F PPOLOG command
Request that VTAM start or stop sending copies of VTAM operator commands and VTAM messages to the primary program operator (PPO):
F PROFILES command
Refresh an active application's set of RACF® profiles:
F RESOURCE command
F RTP command
Request that VTAM search for the best high performance routing (HPR) route, based on transmission group weight, between the two endpoints of a rapid transport protocol (RTP) connection:
F SECURITY command
F SESSION command
Request that an NCP change the session limit (the maximum number of concurrent line scheduling sessions allowed) for a nonswitched multipoint line to one or more attached start/stop or BSC terminals:
F SUPP command
Change the message suppression level after VTAM has been started:
F TABLE command
F TGP command
Change the transmission group (TG) profile associated with a 2.1 connection:
F TNSTAT command
Initiate global or TRLE tuning statistics. Also used to alter the CNSL and TIME tuning statistics values.
F TOPO command
F TRACE command
F USERVAR command
F VTAMOPTS command
Change certain values that might have been specified on VTAM start options:

Parent topic: VTAM commands