Explanation
VTAM® issues
this message as part of a subgroup of messages to provide adjacent
SSCP table information in response to a DISPLAY SRCHINFO,SID command
or when a session initiation fails for either of the following reasons:
- Trial and error routing using an adjacent SSCP table has failed.
The destination LU was found by an SSCP, but that sscpname rejected
the session initiation with sense.
- Trial and error routing using an adjacent SSCP table has exhausted
the table. All adjacent SSCPs were tried, but the destination LU was
not known to any of the SSCPs.
This message subgroup is displayed in a message group
headed by IST663I or IST1531I. A complete description of the message
subgroup follows.
IST894I ADJSSCPS TRIED FAILURE SENSE ADJSSCPS TRIED FAILURE SENSE
IST895I sscpname sense [sscpname sense]
⋮
IST894I - This message is a header message for information displayed in
message IST895I.
System action
The session setup failed.
Operator response
Save the system log for problem determination
and provide the files used for system definition.
System programmer response
Use the output and system definition
files provided to assist in determining the cause of the problem.
(You may need to work with system programmers in other networks to
determine the adjacent SSCP tables used in another network to define
the system.)
Routing code
Descriptor code