Explanation
VTAM® rejects
the
command for one of the following
reasons:
- EXCEEDS limit CHARACTER LIMIT
- The command exceeded the maximum allowable
length limit. The command length should be less
than or equal to the limit limit. The permissible
command length will be smaller if PPOLOG=YES is in effect.
- NO COMMAND OPERANDS
- The command’s input command length (after
removing the command prefix) was 0.
- CMIP SERVICES ALREADY ACTIVE
- The MODIFY VTAMOPTS command for CMIP services has been issued
and CMIP services has already been started.
System action
VTAM rejects
the command.
Operator response
- If reason is EXCEEDS limit CHARACTER
LIMIT, shorten the command to be less than or equal to limit and
reenter it.
- If reason is NO COMMAND OPERANDS, reenter command with
the required operands.
- If reason is CMIP SERVICES ALREADY ACTIVE,
and CMIP services is deactivating, wait until one of the following
messages is displayed indicating that deactivation is complete.
- IST1396I
- IST1397I
- IST1398I
- IST1331I
Reissue the MODIFY VTAMOPTS,OSIMGMT=YES command.
System programmer response
Routing code
Descriptor code