Explanation
During activation or resource takeover, the NCP definition,
configname,
failed for one of the following reasons:
- There is no valid macrotype definition statement in the
NCP definition.
- The NETID operand was specified in each macrotype definition
statement of the NCP definition, but none of the NETID values match
the network ID of this host.
- There is no macrotype definition statement in which the
value of the specified or defaulted SUBAREA operand matches the subareas
of this host. For HOST definition statements, if SUBAREA is not specified,
the subarea value defaults to 1, but this can cause a mismatch if
the HOSTSA start option value was different. For PCCU definition statements,
the SUBAREA operand value defaults to the subarea of this host.
- The HOST definition statement must be specified for locally attached
pre-V4R3 NCPs.
- The BUILD definition statement was encountered before a valid
PCCU definition statement (either the PCCU definition statement was
not specified or none were found that specified a matching NETID and
SUBAREA).
System action
Activation of the NCP definition deck fails during network definition.
Operator response
Save the system log for problem determination.
System programmer response
Correct or include a macrotype definition statement with
the proper NETID and SUBAREA values (or defaults).
Routing code
Descriptor code