IST490I

Explanation
 Processing of command1 causes VTAM® to reject command2 for nodename because command1 takes
precedence over command2. For example, the VARY REL
command causes any subsequent VARY INACT for the same node to fail. 
 Note: If
this message is displayed on a VARY ACT of an NCP with command2 having
the value SSCP TKOVR and command1 having
the value INACT GVBK, then the switched major node has not
been activated before the NCP.
 See Command and RU types in VTAM messages for a description of command1 and command2.

System action
 Processing of command1 continues,
but VTAM rejects command2.

Operator response
 Monitor the progress of command1 with
DISPLAY commands. When command1 processing has
completed, enter the command required to achieve the desired network
configuration or device.
 In the above example, if you want nodename to
be an active part of the network, enter a VARY ACQ command for nodename followed
by a VARY ACT command for nodename. Save the system
log for problem determination. 

System programmer response
 Check the system log to determine
the series of commands that caused the problem. 

Routing code
 2

Descriptor code
 5 