Explanation
While processing macro
macroname during
activation of a switched SNA major node, VTAM® bypassed configuration
configname because
of an error shown by
code, as follows:
- Code
- Meaning
- 1
- The MAXDLUR, MAXNO, or MAXGRP value on the VBUILD definition statement
is zero or is the default.
- 2
- The MAXPATH value on the preceding physical unit definition statement
is zero or is the default.
- 3
- The number of paths specified exceeds the MAXPATH value of this
physical unit.
- 4
- The number of unique dial numbers and unique line names exceeds
the MAXNO value specified on the VBUILD definition statement.
- 5
- The number of unique group names exceeds the MAXGRP value specified
on the VBUILD definition statement.
- 6
- The number of unique dial numbers and unique line names exceeds
the MAXNO value specified on the VBUILD definition statement.
- 7
- The number of PATH definition statements that code DLCADDR for
a single switched major node exceeds the maximum allowed.
System action
Processing continues. VTAM does not add the configuration specified
in the message to the VTAM network.
Operator response
Save the system log for problem determination.
Keep a record of the occurrences of this message.
System programmer response
Correct the problem indicated by code in
this message. After correcting the error, tell the operator to use
the VARY command to activate the configuration again.
Routing code
Descriptor code