This message is part of a group of messages which VTAM® issues when a DISPLAY ID command
is entered for a TCP/IP major node. A complete description of the
message group follows.
IST075I NAME = nodename, TYPE = TCP/IP MAJOR NODE
IST486I STATUS= currentstatus, DESIRED STATE= desiredstate
IST1342I DNSUFX = dnsufx
[IST1343I dnsufx_continuation]
IST1692I TCB = taskno TCP PORT = portno
IST1400I DGTIMER = dgtimer EXTIMER = extimer
IST1406I CONTIMER = contimer IATIMER = iatimer
IST654I I/O TRACE = {ON|OFF}, BUFFER TRACE = {ON|OFF} [– AMOUNT = value]
IST170I LINES:
IST232I linename, status,[CUA = device address]
IST314I END
IST075I - nodename is the name of the resource that
was entered on the DISPLAY ID command.
- Type is always TCP/IP MAJOR NODE for this display.
IST232I - linename is the name of a leased line defined
for a type 5 physical unit, a switched line defined for a type 2 physical
unit, or a VCNS line.
- status is the condition or state of the channel-to-channel
adapter or the token-ring sub-system.
- device address is the hexadecimal channel
unit address of linename. device address is
only displayed for a communication adapter.
IST486I - currentstatus is the current status of the
node.
- desiredstate is the node state that is desired.
If VTAM cannot determine the
desired state, desiredstate