IST095A

Explanation
 This message prompts the VTAM® operator to determine whether VTAM should dump the communication controller
associated with the network control program represented by controller.
 The
prompt occurs when the communication controller has failed and AUTODMP
has not been specified on the PCCU macro. Therefore, the operator
can choose whether or not to dump the contents of the communication
controller.

System action
 VTAM waits
for a valid reply. 

Operator response
  Reply YES for a dump of the contents of the communication controller
using the link station specified at NCP generation or by the VARY
ACT command.
Reply YES,DUMPSTA=linkstaname, where linkstaname is
the value coded for the DUMPSTA operand of the PCCU macro in the NCP
generation.  If you specify YES,DUMPSTA= without naming the link
station, VTAM selects a default
dump station.

Reply NO if you do not want to dump the contents of the communication
controller.

  Notes: You should have instructions from the system programmer as to
which of the replies you should enter at your console. Operators of
multiple-channel or multiple-link attached communication controllers
should avoid replying YES simultaneously to this message. Only one
operator should reply YES to this message. Other operators should
wait for that operator’s dump to be completed and then should
enter NO. 
For additional information on how to respond to this message,
see Responding to a VTAM message.

System programmer response
 None. 

Routing code
 1

Descriptor code
 2 