Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
Step 5. Check the output z/OS Communications Server: SNA Diagnosis Vol 1, Techniques and Procedures GC27-3667-00 |
|
After processing is complete, check the following data
sets for your results:
If you do not get the expected output, check the SUMMARY and LOG data sets for error messages or other information on what might have caused the problem. For example, the SUMMARY data set contains the parameters used for the job, including the parameters specified and the defaults taken. If the trace has wrapped, indicate this on the I/O Options panel or use the WRAP parameter. If the GTF trace tapes were specified in the wrong order, correct the order of the tapes in the JCL. In either case, submit the job again. |
Copyright IBM Corporation 1990, 2014
|