Step 3. Create the parameters for the job

z/OS Communications Server: SNA Diagnosis Vol 1, Techniques and Procedures

Previous topic | Next topic | Contents | Contact z/OS | Library | PDF

Step 3. Create the parameters for the job

z/OS Communications Server: SNA Diagnosis Vol 1, Techniques and Procedures
GC27-3667-00

To create the parameters needed to analyze your VIT, perform the following steps:

Use the panel interface. On the VTAM® Internal Trace Analysis panel, specify the form of processing you want to use. Only one function may be used in a session. The panel interface then provides choices and help in specifying values for the parameters, and creates the PARM data set.
Pick option 1, 2, or, 3 from the Figure 1 ISTT0001 and follow the processing path until you return to the panel ISTT0001. Then choose option 4 to indicate that your input has been completed.
Figure 1. VTAM internal trace analysis option panel
```
ISTT0001               VTAM Internal Trace Analysis
 
Select a choice, then press Enter.
 
 __ 1.  Storage Analysis
    2.  Request/response unit counting
    3.  VIT extraction
    4.  Input Complete
 
 
 
 
 
 
 
 
 
 
 
(C) Copyright IBM Corporation 1993,2002.  All rights reserved.
 Command ===> ___________________________________________________
⋮
```
Note: If an incorrect value is entered in a field, the cursor appears on the field where the error was made. For help about that field, press F1.
Use an editor to either:
- Create a parameter data set.
- Code the parameters in-stream in the JCL created in step 2.
See the parameter syntax for a particular function, and Creating your own parameter data set for further details.

See "How to read a syntax diagram" for general information on how to code and read syntax diagrams.

Go to the previous page

Go to the next page

Notices | Terms of use | Support | Contact z/OS | zFavorites

Copyright IBM Corporation 1990, 2014