- The virtual route selection exit routine receives:
- Address of VR1,TP1 descriptor block
- Address of VR2,TP1 descriptor block
- Address of VR3,TP0 descriptor block
- (*)Address of VR4,TP2 descriptor block
- The virtual route selection exit routine turns on the high-order
address bit in VR2,TP1 and returns to VTAM®:
- Address of VR1,TP1 descriptor block
- (*)Address of VR2,TP1 descriptor block
- Address of VR3,TP0 descriptor block
- Address of VR4,TP2 descriptor block
- VTAM uses only VR1,TP1
and then VR2,TP1 to establish the pending session. If neither route
can be activated, the session-establishment request is terminated
because no paths are available.
|