WRAP parameter

Use the WRAP parameter with the SDATE/EDATE and STIME/ETIME parameters to select GTF data sets. For information about the date and time parameters, see S/EDATE and S/ETIME parameters.

The following is an example:


   .-WRAP=NO-----------.   
>>-+-------------------+---------------------------------------><
   '-WRAP=--+-YES----+-'   
            '-IGNORE-'

NO

This is the default if a value is not specified or the parameter is reset. A GTF data set stops processing the first time a record is found with a date or time stamp greater than the values specified for EDATE and ETIME.

YES

Specify this value if you want the entire GTF data set scanned for records that match the selection criteria specified in the SDATE, STIME, EDATE, and ETIME settings. This provides support for wrapped GTF data sets.

If data within the requested time or date range appears twice in a wrapped GTF data set, use WRAP=YES to enable formatting of all data within the time requested range.

IGNORE

This value has the same effect as WRAP=YES except that printing of wrap informational messages (as shown) is suppressed.

DSJ242I RECORD XXXXXXX CONTINUITY ERROR - TIMESTAMP WRAPAROUND

If you specify WRAP=YES or IGNORE, ACF/TAP continues processing wrapped GTF data sets after a specified EDATE or ETIME parameter is exceeded.