TOSUP parameter

Use the TOSUP parameter to suppress the printing of timeout messages generated by timeout conditions on any SDLC receive command. Instead of printing each message, ACF/TAP counts the number of messages and prints this count in the reports. Use this parameter primarily for frame-relay physical line trace data because of the numerous timeout messages generated in this environment and it affects the line trace summary report only.

The following is an example:


   .-TOSUP=YES-.   
>>-+-----------+-----------------------------------------------><
   '-TOSUP=NO--'

YES: This is the default if a value is not specified or the parameter is reset. The printing of timeout messages is suppressed for receive commands and only the number of messages received is reported.
NO: This value allows messages generated by timeout conditions to be shown in the trace output report.