Use the START and END parameters to select records for
processing based on ACF/TAP-assigned message counts.
- count
- This value specifies the ACF/TAP-assigned message count where
selection of trace records for processing should start or end.
You
can also specify starting and ending counts when a trace file is scanned
(INPUT=SCAN). If you specify INPUT=SCAN, analysis is not done on trace
records. The count limits apply to the number of records scanned.
If you specify SUMMARY=EVERY, the count limits apply to every trace
record on the file. If you do not specify the SUMMARY parameter, the
scan count applies only to trace records that ACF/TAP can process.
Restrictions: - START and END are valid only for buffer traces.
- ACF/TAP processes only the records with message counts between
those specified by START and END parameters.