Use the LLN parameter to select the logical line numbers
for NTRI line traces and hardware addresses for ESS line traces.
.-LLN=ALL-------------.
>>-+---------------------+-------------------------------------><
'-LLN=aaaaaaaaaaaa:bb-'
- ALL
- This is the default if a value is not specified or the parameter
is reset. All NTRI logical line numbers and ESS hardware addresses
in the trace data are selected.
- aaaaaaaaaaaa:bb
- Use this value to specify which logical line number is selected.
- aaaaaaaaaaaa
- This value specifies the destination or source address of the
NTRI line to be selected or the ESS hardware address (locally administered
or universal) of the data to be traced. The address is a hexadecimal
number in the range X'000000000000' - X'7FFFFFFFFFFE'.
- bb
- This value specifies the system access point, the destination
system address point (DSAP), or the source system address point (SSAP)
of the logical line to be selected. When traces for multiple logical
lines appear in the trace data set, you can select one for formatting
by specifying the DA/DSAP or SA/SSAP pair. If either the destination
address and DSAP pair or the source address and SSAP pair matches
the logical line address specified, the element is formatted.
Tips: - Specify two asterisks (**) for the DSAP or SSAP to show all entries
for a particular source or destination address.
- Use two asterisks in place of the service access point (SAP) for
ESS data other than 802.3 snap encapsulated data because there are
no SAPs.