Use the INPUT parameter to specify the input file trace
data that you want to be processed.
.-INPUT=ALL--------------.
>>-+------------------------+----------------------------------><
'-INPUT=--+-+-BUFFER-+-+-'
| +-BUFF---+ |
| +-BUF----+ |
| +-BFFR---+ |
| '-PIU----' |
+-LINE-------+
+-SCAN-------+
+-GPT--------+
+-NETCTLR----+
'-VIT--------'
- ALL
- This is the default if a value is not specified or the parameter
is reset. All trace records types in the trace data set are processed
with one run of ACF/TAP.
- BUFFER, BUFF, BUF, BFFR, PIU
- Specify this value to process a VTAM® buffer
trace. Any of the abbreviations listed here can be used.
- LINE
- Specifying this value causes the following trace records to be
processed:
- NCP line
- SIT
- Transmission group
- NTO internal and FIDO
- NRF
- NTRI
- TIC
- X.25
- Frame-relay
- ESS trace
- CSS line and adapter traces
The NTRI line trace includes the NTRI IOH trace. When you
activate an NTRI line trace, the IOH trace is automatically activated.
- SCAN
- Specify this value if you want only summary data to be collected
for all trace records in the trace data set. Analysis is not done
on the trace records, and only a SYSPRINT report is produced. If
INPUT=SCAN, the SUMMARY parameter is set to ALL, unless you specify
SUMMARY=EVERY.
For more SUMMARY parameter information, see Summary parameter. For information
about messages DSJ201I and DSJ205I, see Messages.
- GPT
- Specify this value to process the generalized PIU trace (GPT)
records. If you specify this value, see the NCPNAME parameter in NCPNAME parameter.
- NETCTLR
- Specify this value to process the network controller trace for
the IBM® 3710 Network Controller.
- VIT
- Specify this value to process the VTAM internal
trace (VIT).