If you are a RACF-defined user, and this is your first logon using the full-screen logon panel:

1. Enter LOGON yourid. TSO/E displays the following panel with default values:

   ------------------------------- TSO/E LOGON ----------------------------------
   PF1/PF13 ==> Help    PF3/PF15 ==> Logoff    PA1 ==> Attention    PA2 ==> Reshow
   You may request specific HELP information by entering a '?' in any entry field.
      ENTER LOGON PARAMETERS BELOW:                  RACF LOGON PARAMETERS:
   
      USERID    ===> YOURID                          SECLABEL     ===>
   
      PASSWORD  ===> -                               NEW PASSWORD ===>
   
      PROCEDURE ===> MYPROC                          GROUP IDENT  ===>
   
      ACCT NMBR ===> 00123
   
      SIZE      ===> 5800
   
      PERFORM   ===>
   
      COMMAND   ===> EXEC (SETUP)
   
   
      ENTER AN 'S' BEFORE EACH OPTION DESIRED BELOW:
   
             -NOMAIL         -NONOTICE        -RECONNECT         -OIDCARD

2. Enter your password (commonly a group password) in the PASSWORD field. If you wish to change your password, enter the new password in the NEW PASSWORD field. You may also enter other logon operand values.
3. Press the Enter key to enter your input to TSO/E. After preliminary messages, TSO/E generally displays three asterisks, ***. Whenever you see ***, press the Enter key to continue. You then see the READY message:

   READY

   If you specified a command in the COMMAND field of the logon panel, in this case, EXEC (SETUP), TSO/E processes your command. Had you left the COMMAND field blank, you could begin entering commands immediately after the READY message.

When you log on to TSO/E using the full-screen logon panel, the values shown in some of the fields, such as PROCEDURE, ACCT NMBR, and SECLABEL are the values you entered for your previous TSO/E session. You can choose a different value by typing in a new value in the field. The new value you enter is then saved and is displayed whenever you log on again until you either enter a different value or blank out the field.

The values you are required to enter on the logon panel depend on your installation. See your TSO/E administrator for logon instructions.