Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
Updating the UADS and the broadcast data set z/OS TSO/E Customization SA32-0976-00 |
|
To update the UADS and the broadcast data set from a terminal, ensure that the UADS to be updated is allocated by the SYSUADS DD statement, either in a LOGON procedure or by using the ALLOCATE command. Make the updates (additions, changes, and deletions) using the ACCOUNT command and its subcommands. To update the UADS and the broadcast data set with a batch job, you can use the sample JCL shown in Figure 1. For an explanation of this JCL, see Executing the terminal monitor program. If you do not include a DD statement specifying the broadcast data set, the data set must be cataloged. Figure 1. Updating
the UADS with a batch job
Note: With dynamic broadcast support, the SYSLBC DDNAME is no longer
required. If the SYSLBC DDNAME is not specified, the currently active
broadcast data set will be used by the job. If the SYSLBC DDNAME
is specified, the referenced data set will be used by the job.
|
Copyright IBM Corporation 1990, 2014
|