Explanation
After the message, a heading appears:
VOLUME
S1 S2 S3 S4 S5 S6 S7 S8 S9 S10 S11 S12 S13 S14 S15 S16
Then
one or more of the following lines appear:
VOLUME S17
S18 S19 S20 S21 S22 S23 S24 S25 S26 S27 S28 S29 S30 S31 S32
Then
the following lines appear:
******************* LEGEND
********************
E = SYSTEM IS ELIGIBLE TO ACCESS SMS VOLUME
N = SYSTEM IS NOT ELIGIBLE TO ACCESS SMS VOLUME
SYSTEM 1 = sysname SYSTEM 2 = sysname SYSTEM 3 = sysname
SYSTEM 4 = sysname SYSTEM 5 = sysname SYSTEM 6 = sysname
SYSTEM 7 = sysname SYSTEM 8 = sysname SYSTEM 9 = sysname
SYSTEM 10= sysname SYSTEM 11= sysname SYSTEM 12= sysname
SYSTEM 13= sysname SYSTEM 14= sysname SYSTEM 15= sysname
SYSTEM 16= sysname SYSTEM 17= sysname SYSTEM 18= sysname
SYSTEM 19= sysname SYSTEM 20= sysname SYSTEM 21= sysname
SYSTEM 22= sysname SYSTEM 23= sysname SYSTEM 24= sysname
SYSTEM 25= sysname SYSTEM 26= sysname SYSTEM 27= sysname
SYSTEM 28= sysname SYSTEM 29= sysname SYSTEM 30= sysname
SYSTEM 31= sysname SYSTEM 32= sysname
A job
requested locates, but the storage management subsystem determined
that the locates could not be performed. The catalogs required for
locate processing reside on SMS managed volumes that are not all defined
to one common system.
In the message text:
- sysname
- A system in the current active configuration.
- volser
- The volume serial of an SMS managed volume. There is one volser entry
for each SMS managed volume that contains a catalog required by the
job for locate processing.
- c
- An indication of whether a system can access the volume, as follows:
- ‘E’ if the system is eligible to access the SMS managed
volume. In this case, volser is defined to the
system, and has a storage management subsystem status of ‘ENABLE’, ‘QUIESCED’, ‘QUIESCE
(NEW)’, ‘DISABLE’, or ‘DISABLE (NEW)’.
- ‘N’ if the system is not eligible to access the SMS
managed volume. In this case, volser is not defined
to the system.
System action
Programmer response
Make sure that all volumes in the display
are defined to at least one of the systems in the active configuration.
Then you can resubmit the job.
Source
Routing code
Descriptor code