IGD074D

Explanation
This message gives the operator the opportunity
to correct, change, or add to the specified storage management subsystem
values. IGD074D appears either during storage management subsystem
initialization or in response to the SET SMS command, only if one
of the following conditions exists: PROMPT=YES is specified in the storage management subsystem record
of SYS1.PARMLIB member IEFSSNxx; in this case, message IGD031I also
appears.
An error is detected in the IGDSMSxx SYS1.PARMLIB member, but
all of the required keywords have been specified.

In the message text: keywd
The specified keyword.
value
The keyword value.

System action
The system waits for the operator to respond to
this message before allowing storage management subsystem initialization
to continue. The system issues message IGD030I to describe the error.

Operator response
You can enter the following replies: A keyword value, which will correct, change, or add a storage
management subsystem value. Enter only one value per prompt; this
message will reappear until you enter either ‘C’ or ‘S’.
‘D’, which will default all of the storage management
subsystem values except those that are required.
‘C’, which will operate differently depending on the
circumstances under which you issue it: If you reply ‘C’ during storage management subsystem
initialization, the initialization process is cancelled. Therefore,
the subsystem is defined but inactive. You may activate the subsystem
later via the SET SMS command.
If you issue ‘C’ when the storage management subsystem
is active and you have issued SET SMS, the SET SMS operation is cancelled.
Therefore, the storage management subsystem will continue to operate
with the previously specified values.

‘S’, which will save all the storage management subsystem
values that have been specified up to this point. If any required
values are unspecified or incorrect, you must provide or correct them
before replying ‘S’.

 See z/OS MVS System Commands for
information about the SET SMS command.

Source
DFSMSdfp

Routing code
1

Descriptor code
2