- Use the JES2 reconfiguration dialog to move the checkpoint data
set to another CF or to DASD.To use the dialog, ensure that you have
defined a NEWCKPTx in the JES2 CKPTDEF initialization statement in
one of the following ways:
- JES2 initialization parameters
- Dynamically through the $T CKPTDEF command
- Issue the following JES2 command to switch to the alternate checkpoint
data set:
$T CKPTDEF,RECONFIG=YES
Follow the reconfiguration
dialog prompts.
When finished, issue the following JES2 display
command to verify that the structure is not still in use by JES2:
$D CKPTDEF
- Deletion of the structure might need to be forced. See Deleting structures with SETXCF FORCE for more information on forcing deletion of persistent
structures with the system command:
SETXCF FORCE,STRUCTURE,STRNAME=strname
- If necessary, change the JES2 initialization parameters to point
to the new checkpoint data set for the next JES2 warm start.
To re-initiate use of the JES2 checkpoint structure, issue the
JES2 command:
$T CKPTDEF,RECONFIG=YES
Follow the reconfiguration dialog prompts.