|
- REMOTEnnn
- Specifies the identification number assigned to the remote station
asking to sign on. The nnn is 1 through 3 decimal numbers.
Code
REMOTEnnn with the same characters as RMTnnn on the /*ROUTE statement.
If you code REMOTEnnn on the /*SIGNON statement, you are restricted
to coding RMTnnn with only three numbers on the /*ROUTE statement.
- RMTnnnn
- RMnnnn
- Rnnnn
- Specifies the identification number assigned to the remote station.
nnnn is one through four decimal numbers.
- NxxRnnnn
- Specifies the node number in the NJE network and the identification
number assigned to the remote station. Nxx must specify the node to
which the remote work station is connected. xx is 1 through 1000.
nnnn is 1 through 4 decimal numbers. xx plus nnnn cannot exceed 6
numbers.
- dest-name
- Specifies the name (one through eight characters) that you use
to refer to the JES2-defined destination. The dest-name must be defined
as a remote work station on the system to which the terminal is connected.
- password1
- Specifies the password assigned to a nondedicated connection
that allows the remote station access to JES2 for remote job stream
processing. The installation assigns this password during system
initialization. The operator can change or delete this password with
the $T command.
- new-password
- Specifies a new password for the remote job entry (RJE) station
that is signing on. If the installation is controlling the sign on
with JES2 password support instead of RACF®, the
new password is ignored.
- password2
- Specifies the current password for the remote station that is
signing on; this password identifies the remote station as a valid
remote job entry (RJE) station. This parameter is assigned by either RACF,
a JES2 initialization parameter (if JES2 password support is used),
or the $T command.
|