The SELECT command is supported on all results lists. You can use this primary command to apply the same line command to all selected entries in a search results list table. For example, all volumes in the volume result list are ejected when you issue:

Command ===>SELECT * E

in a volume search results list.

You can specify a generic value for the first parameter, or a specific value. For example, issue:

SELECT AB0* V

to view volume data for all volumes starting with AB0, or issue:

SELECT MW0001 R

to release the volume MW0001, if found in the list.

The first parameter is applied on the first key of the table. If you want another column of the table to be taken as the select criteria, issue a SORT command before the select command. For example, first SORT by owner, then issue:

SELECT GEORGE E

to eject all volumes of owner GEORGE.