Status codes from RENAME

After the RENAME macro instruction is executed, the last byte of each 12-byte entry in the volume list indicates one of the that are described in Table 1.

Table 1. Status Codes from RENAME Macro Instruction
Rename Status Code	Description
0 (X'00')	The format-1 DSCB for the data set has been renamed in the VTOC on this volume.
1 (X'01')	The VTOC of this volume does not contain the format-1 DSCB of the data set to be renamed.
2 (X'02')	One of the following conditions occurred: The data set could not be renamed because the data set was password protected and the password was not supplied in the two attempts allowed. An attempt was made to rename a VSAM data space or a catalogued VSAM data set. An attempt was made to rename a VTOC index data set. An SMS validation failure occurred.
3 (X'03')	A format-1 DSCB containing the new data set name already exists in the VTOC of this volume, or an attempt was made to rename a data set to a name starting with 'SYS1.VTOCIX'
4 (X'04')	One of the following conditions occurred: A permanent I/O error occurred while trying to rename the data set on this volume. An incorrect format-1 DSCB was encountered while processing this volume. No space is available in the index VIER for the new name, and no additional VIERs are available.
5 (X'05')	It could not be verified that this volume was mounted nor was a unit available for mounting the volume.
6 (X'06')	The operator was unable to mount this volume.
7 (X'07')	The data set was not renamed, because it was currently open for processing.
8 (X'08')	The data set is defined to RACF®, but either you are not authorized to access the data set or the data set is defined to RACF on multiple volumes.