Adding values to the tape volume information

If, when the volume was entered into the library, no values were specified for storage group name, shelf-location, or owner information, the OLD VALUE fields on this panel are blank and the tape volume record reflects blanks in these fields in the TCDB. The storage administrator then adds the values for owner information, storage group, and shelf location into the NEW VALUE field and hits ENTER. The fields are updated in the TCDB, and the next time the volume is displayed, the new information appears in the OLD VALUE fields. The NEW VALUE field is primed with the same information as well (see Figure 1).

Figure 1. Both OLD VALUE and NEW VALUE reflect the values assigned to the Volume

   Panel  Utilities  Help
 --------------------------------------------------------------------------------
                    MOUNTABLE TAPE VOLUME ALTER ENTRY PANEL
 Command ===>
 
 Tape Volume:EMB001
 
 Specify New Values for the Following fields:      (leave as-is if no change)
 
 Use Attribute: Old Value   :PRIVATE
                 New Value . . P        (P - Private or S - Scratch)
 
 Storage Group: Old Value   :MTLGRP1
                 New Value . . MTLGRP1
 
 Shelf Location:Old Value   :EILEENS DESK
                 New Value . . EILEENS DESK
 
 Owner Information:
     Old Value:EILEEN
 New Value  . . EILEEN
 
 Use ENTER to Perform ALTER;
 Use HELP Command for Help; Use END Command to Exit.