INTEGRATED CATALOG FORWARD RECOVERY UTILITY V2R1
CRURRAP SYSPRINT 02/04/13 (13.035) 11:25:16 PAGE 1
RECORD ANALYSIS AND PROCESSING REPORT
EXECUTION PARAMETERS
CATALOG NAME CATEI001.UCAT1
RECORD SELECTION START 02/04/13 (13.035) 11:24:39
RECORD SELECTION STOP 02/04/13 (13.035) 11:25:02
SIGNIFICANT GAP TIME 0030 MINUTES
MAXIMUM CLOCK DIFFERENCE 0000 SECONDS
CATALOG WAS EXPORTED ON 02/04/13 AT 11:24:39
The first page of the reports from Record Analysis And Processing
lists the execution parameters. Because the results must be viewed
relative to these values, review the parameters to make sure that:
- The correct catalog name was specified
- The start date and time correspond to the date and time of the
backup data set to be used for recovery
- The stop date and time correspond to the date and time when it
was confirmed that the catalog was closed in preparation for recovery
- The gap specification (in minutes) is smaller than the shortest
time interval spanned by a single SMF data set
- The multi-system clock difference (specified in seconds) is at
least as large as the maximum difference between the time-of-day clocks
on any two systems.
- The date and time that the catalog was exported correspond
to the date and time of the portable data set to be used for recovery
was created.