IRRI004I

Explanation
This is an attention message only.  You can choose
whether to act immediately. RACF® checks
certain data between the partner node and the local node to determine
whether a command could run on one node but not the other.  The template
level is an example of this data and a mismatch are detected. Adding
a field on one node may work, but fail on the other node until the
corresponding template update takes place on that node. If SYSNAME
information is present for one or both of the nodes in this message,
the node that precedes the SYSNAME is a multisystem node.

System action
If no error messages are issued with this attention
message, RACF still attempts
to move this node pair into the OPERATIVE ACTIVE state. Message IRRI001I
tells you when the OPERATIVE ACTIVE state is reached.

System programmer response
Evaluate the template levels in the
message. If you do not plan to add or alter a profile specifically
using the fields in the more recent version of the templates, you
may ignore this message until the next service upgrade causes the
templates to match.  If you plan to use the new fields, you must correct
the template mismatch by running the IRRMIN00 utility on the downlevel
node, then IPL that node. Remember to upgrade the RACF dynamic parse specification data set (IRRDPSDS)
to match the template level. When the template levels match, this
message does not appear when the two nodes TARGET each other.

Routing code
2 and 9

Descriptor code
4