Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
IRRI000I z/OS Security Server RACF Messages and Codes SA23-2291-00 |
|
IRRI000I LOCAL RACF NODE local-node [SYSNAME system-name]
IS ATTEMPTING TO CONTACT PARTNER RACF NODE partner-node [SYSNAME system-name]. ExplanationThis is an informational message only. One or more RACF® TARGET commands were issued at the local RACF node local-node that caused it to attempt to establish communications with the partner node partner-node. The local node waits for a response from the partner (the partner should issue its own TARGET command). Once the partner responds, information is exchanged and an attempt is made to open up RACF communication between these two nodes. This is known as entering the OPERATIVE ACTIVE state. This message is written to the SYSLOG. If SYSNAME information is present for one or both of the nodes in this message, the node that precedes the SYSNAME is a multisystem node. System programmer responseIf you receive this message and do not get a response either confirming or denying communication, ensure that the partner RACF node did issue a TARGET statement for this node (with the correct LU name, if APPC is being used, or the correct host address, if TCP is being used). A TARGET NODE (node-name) LIST command can be issued on the partner node to list the node definition as it is defined here. You should also check for communication protocol failures (that is, APPC or TCP), because that is the means RACF is using to communicate with the partner. |
Copyright IBM Corporation 1990, 2014
|