IRRV007I

Explanation
An attempt was made to direct a RACF® command to a node that is not currently
active. This message is for your information only to warn you that
there may be a delay before the command actually runs at the target
node. This message is sent to the user's TSO terminal.

System action
RACF sends
the command request to the RACF subsystem
where it is saved.  Message IRRV008I follows this message to indicate
that the command is saved.  Once the target node is made operative,
the saved commands are processed. Your commands are processed in the
same order as you issued them.

User response
None required.  However, if you need the RACF command change to take effect
immediately, do one of the following: Contact the system programmer to activate the node.
Issue the command directly on the target system.  This requires
you to log on to the target node and issue the command without the
AT (or ONLYAT) keyword.