z/OS Security Server RACF Messages and Codes
Previous topic | Next topic | Contents | Contact z/OS | Library | PDF


IRRC030I

z/OS Security Server RACF Messages and Codes
SA23-2291-00

IRRC030I
RACF REMOTE SHARING MODULE module-name HAS EXPERIENCED A FAILURE WITH THE VSAM FILE data-set-name. IRRSSQ00 REQUEST = request, IRRSSQ00 RC = module-return-code, VSAM RC = vsam-return-code, SHOWCB RC = showcb-return-code, VSAM REASON CODE = vsam-reason-code

Explanation

RACF® remote sharing experienced a failure when it attempted to checkpoint a request to a specific VSAM file. The IRRSSQ00 REQUEST is either:
  • R - read
  • X - read_next
  • I - insert
  • E - erase
The IRRSSQ00 RETURN CODE indicates a VSAM failure:
Code
Explanation
4
MODCB RPL ACB
5
MODCB RPL AREA
6
MODCB RPL RECLEN
7
MODCB RPL ARG
8
MODCB RPL OPTCD=NUP
9
GET
A
PUT
B
ERASE
C
ENDREQ
E
OPEN

The VSAM RETURN CODE, SHOWCB RETURN CODE, and VSAM REASON CODE definitions may be found in ../com.ibm.zos.v2r1.idad500/dgt3d500.htm. If the SHOWCB RETURN CODE is non-zero, the value for the VSAM REASON CODE should be ignored.

System action

The RACF subsystem address space is not able to send or receive remote sharing requests for the specified node.

Operator response

Determine why RACF remote sharing experienced the failure when checkpointing information to the VSAM file. Typical causes of this problem are the VSAM file is full or the disk containing the VSAM file is experiencing I/O errors. Check for other instances of either this message, or message IRRC029I, and LOGRECs. Correct the problems. When the problem is resolved, start the node by using the TARGET command (for example, TARGET NODE(x) OPERATIVE ...).

Routing code

2

Descriptor code

6

Parent topic: RACF subsystem messages

Go to the previous page Go to the next page

Notices | Terms of use | Support | Contact z/OS | zFavorites



Copyright IBM Corporation 1990, 2014